iamxd 0 Posted February 15, 2018 (edited) Hi, after i replaced the Rotor because bearing had too much play, now i cant wind the movement using the crown. It is somehow blocked and doesnt turn clockwise, date setting and time hacking works without any problems. btw its a 2836 clone / eta Edited February 15, 2018 by iamxd Share this post Link to post Share on other sites
Rx4Time 1,472 Posted February 15, 2018 What did you replace exactly? The rotor and bearing or more? What is your replacement part? Gen ETA or another clone? If you swap back in the loud rotor, will it work correctly? Share this post Link to post Share on other sites
Joyjoyk 0 Posted February 15, 2018 (edited) 1 hour ago, iamxd said: Hi, after i replaced the Rotor because bearing had too much play, now i cant wind the movement using the crown. It is somehow blocked and doesnt turn clockwise, date setting and time hacking works without any problems. btw its a 2836 clone / eta Did u lose a screw in the movement? Had similar thing happen to my Panerai 512. Screw came loose and was floating around.. found itself lodged between the stem and the plate Edited February 15, 2018 by Joyjoyk Share this post Link to post Share on other sites