Wirral_guy 0 Posted December 12, 2011 Hi I recently got a PP Nautilus from WBK and it has become my daily wearer. The only issue I have is that the bracelet pins, that attach it to the case, start to ease out over the course of a day. They are about 25mm long with a knurled portion at one end. Can you get replacements of these that fit a little more snugly? Or is there a better way of holding them in\the bracelet attached? Thanks Dave Share this post Link to post Share on other sites
BRANCE 0 Posted August 14, 2017 Hi D. I have the same issue. Did you ever find a solution? Cheers, B. Share this post Link to post Share on other sites
Diver Dave 0 Posted August 20, 2017 (edited) Necro-Thread, but... with the recent question added, here goes: Typical repair for many different micro-machines.... Remove the pin, place it on a steel block, gently tap one end (where it's knurled) with a small machinists hammer to gently flatten it out a bit, and stick it back into your bracelet. It'll hold without problem. Small adjustments are what's needed so tap gently. Edited August 20, 2017 by Diver Dave Share this post Link to post Share on other sites