Hazz 0 Posted June 4, 2012 Having probs removing a crown and stem, I am used to having a screw to loosen, but not sure about the 21j. what tool is needed, screw or alllen too small to figure out. Anyone know ? Thanx, can't get a better pic. Share this post Link to post Share on other sites
DFH 0 Posted June 4, 2012 Better this than a dental situation!!! (crown removal - get it?!!) Share this post Link to post Share on other sites
scope 3 Posted June 5, 2012 Very simple but easy to screw up. You just have to use a small screw driver to push down lightly(repeat lightly)while pulling out the crown.If you push too hard it will bend the plate and screw up the keyless works. Share this post Link to post Share on other sites
OlympusDaytona 49 Posted June 5, 2012 Or a toothpick! Share this post Link to post Share on other sites
Hazz 0 Posted June 5, 2012 Scope.....thanx worked a treat, now I am ready to change case on my milsub. Share this post Link to post Share on other sites
Member X 91 Posted June 5, 2012 I used a bracelet pin pusher tool on one I have It then got stuck down so I had to remove everything from the case and then hold the movement so I could see into the side of it where the pusher operates, then squeeze the mechanism it's attached to back towards the top plate using some needle nosed tweezers lol Share this post Link to post Share on other sites