timelord 0 Posted January 11, 2011 Hello I have purchased some wonderful replicas from the information shared on the forum and have also been saved from very nasty scams. I need to replace a crown and tube on submariner which I accidently threaded . I am aware that different replicas may use different sized parts so to narrow down the type I need was purchased from a dealer trading by the name Aspire, Paul or Gomart? It has been a good workhorse and I didn't want to toss it out as my watchmaker serviced it recently. I did have a generic tube suitable for a genuine and it screwed into the replica case very well, but I need both the crown and tube so that the tread is correct for the crown. If anyone has had a similar experience and is able to assist me please contact me. Thanks!! regards to ALL Share this post Link to post Share on other sites
offshore 0 Posted January 11, 2011 I have a bunch of Rx crowns and matching tubes, but can't tell you the thread on the tube! Give me a hole dia, and I'll see if these are close. O/S Share this post Link to post Share on other sites