ortiizz 0 Posted August 13, 2016 (edited) Hi lads, Was looking for some minor insight on Sea-Gull ST movement – PAM616 (P9000 clone). When plate is rotated counter clockwise it makes a faint clicking sound. I think it was not there when I got it, but just noticed it after I opened her up and did the initial checkup for pubes and what not. It might have also sth to do with one of the faux screws being lost. I think I took it out, but it might have fallen back inside. Not sure, but I couldn't find it on the table. If that is the case, should I try and maybe remove the whole movement and see if it falls out by itself? Or is there any possibility, which I highly doubt, but will ask anyway – that this sound is normal? Short Youtube clip to illustrate the problem: Any tips and pointers are most welcome and thank you all in advance! Edited September 21, 2016 by ortiizz Share this post Link to post Share on other sites
ortiizz 0 Posted September 9, 2016 Have to bump this at least once, especially since it's Fri night. ANY pointers would be much appreciated. Share this post Link to post Share on other sites