steve1954 1 Posted August 20, 2016 Yesterday I was just getting some dog food out of my garage and for some reason the spring bar on my NEW Tudor bronze popped out. The watch hit the concrete floor on the milled edge of the bezel distorting the soft metal and conpressing the bezel insert causing the paint to crack!! - FED up as this is a very nice watch, my current favorite.. Not sure the same damage would have happened with a harder metal Share this post Link to post Share on other sites
klingooo 0 Posted August 20, 2016 What a bad beat. A harder type of metal could've easily cracked instead, if that's any comfort... Share this post Link to post Share on other sites
GenTLe 1,509 Posted August 20, 2016 Mine had the same fate... But I fixed it today When I received it, the watch went straight to my desk to be serviced. While I was cleaning internally the glass, prior to movement re-casing, it slipped from my hands, falling on my tibia and from there to the ground. It touched the ground on a lug and then on the bezel... The lug has been an easy fix with just a little bit of 1000 sandpaper. The insert wasn't touched but it was slightly moved and the bezel ring got slightly bent like yours... Today I removed the bezel, removed the insert and the plastic gasket from the bezel, then I took one of these (the largest I have around): and I cut it to remove the final conic part. I took then a piece of straight wood (beech, because it's not too soft). Finally I took the insert, kept it nearly vertical (let's say 30° tilted respect to the vertical) on the slat of beech, I put the wood spine on the bent part and used a 200g hammer (lightly!) on that spine. After some time it went back to perfection. This way: I also took the chance to grease a bit the insert click mechanism (and now it rotates MUCH better) and to properly re-glue back the insert (I'm currently wait for the glue to dry) Share this post Link to post Share on other sites
steve1954 1 Posted August 20, 2016 good job but not sure I know how to take the bezel off Share this post Link to post Share on other sites
Moondustesp 136 Posted August 20, 2016 Thats a shitter hope you get it sorted Share this post Link to post Share on other sites
gavmeister 1 Posted August 20, 2016 I feel your pain. I guess you could always age the thing now? Share this post Link to post Share on other sites
steve1954 1 Posted August 20, 2016 I feel your pain. I guess you could always age the thing now? Thats an idea!! Share this post Link to post Share on other sites
GenTLe 1,509 Posted August 20, 2016 good job but not sure I know how to take the bezel off It is straightforward. Exactly like here: .But put some tape on the lug not to mark it with the knife. The insert is glued, I used a knife to slowly lift it from the inside of the bezel, where the glue is. Share this post Link to post Share on other sites