Mr_B 2,401 Posted March 30, 2017 Been looking for some info on a ceramic bezel insert swap as I've got a new one on order for a GMT. Any tips appreciated. As far as I'm aware, a little heat on the insert with a soldering iron and some 3M double sided adhesive tape for the new insert? Share this post Link to post Share on other sites
ShovelnTC 31 Posted March 30, 2017 Yes heat and very gently levering around circumference with a sharp blade although I've read lots of reports of broken inserts, not a problem if you are replacing though. Share this post Link to post Share on other sites
muiramas 0 Posted March 30, 2017 Heat it up with a hair dryer, then rotate / twist it off with the pearl as a grip. Dont use a soldering iron, the heat is too focused. Its held in on with a ring of double sided tape which covers the whole back of the insert. Share this post Link to post Share on other sites
