opus9 0 Posted April 22, 2011 PVD Coating...can it be done by a specialist after a stainless steel version has been bought,Is it a complex process etc etc..any one who knows all about this stuff let me know please. Thanks again... opus9 Share this post Link to post Share on other sites
Otek 0 Posted April 22, 2011 (edited) Sure can opus9, not sure if Avitt or Taka still does DLC runs tho..bit pricey but hell of a good job. Im sure theres few more who can do proper DLC on reps Edited April 22, 2011 by Otek Share this post Link to post Share on other sites
Balad1 0 Posted April 22, 2011 PVD Coating...can it be done by a specialist after a stainless steel version has been bought,Is it a complex process etc etc..any one who knows all about this stuff let me know please. Thanks again... opus9 I don't believe it's practical. You could probably buy a 21J PVD version cheaper then the cost of coating the original rep. Share this post Link to post Share on other sites
jameo210369 0 Posted April 22, 2011 I agree with Balad, you would save money by buying the pvd rep. Check the link below Opus http://www.replica-watches-guide.com/forum...showtopic=12828 Share this post Link to post Share on other sites
jdoe 0 Posted April 22, 2011 Think itæll cost more than the watch, check out the Cerakote thread for alternatives Share this post Link to post Share on other sites
