Wiz 0 Posted July 26, 2011 Last week I had a 177L on the bench, and it felt difficult separing the dial plates out. Why? Because the entire front plate was covered with glue! How freaking stupid! Share this post Link to post Share on other sites
greg_r 81 Posted July 26, 2011 Makes a change from sauce, I suppose! Share this post Link to post Share on other sites
Fed949 0 Posted July 26, 2011 ops! Hope is not mine!! Share this post Link to post Share on other sites
Wiz 0 Posted July 26, 2011 ops! Hope is not mine!! Unfortunately it is, but I managed to remove the glue. Share this post Link to post Share on other sites
WebWind 1 Posted July 26, 2011 How did you separate those plates? Mechanically, or by heat and then mechanically or ... Share this post Link to post Share on other sites
Wiz 0 Posted July 26, 2011 How did you separate those plates?Mechanically, or by heat and then mechanically or ... Same as usual, with a knife blade. Share this post Link to post Share on other sites