Comex 0 Posted August 3, 2011 Hello guys, today I received my SA with DHL. It looks absolutly fabulous although the pusher for reset from the chrograph wasn't fastened. It falls ou really easily. I also contacted the guys at Timeshops.net with the same question. Maybe one of you out there has hopefully an answer. Cheers. Share this post Link to post Share on other sites
MikeMcNair 0 Posted August 3, 2011 it screws in bro, put it on, and screw it in. if the actual button itself fell out, the TINY "c-clip" may have fallen off in the movement. got pix? Share this post Link to post Share on other sites
Comex 0 Posted August 4, 2011 You could be right Mike, there is a small slot in the rod where a c-clip could fit in. Mark from Timeshop contacted me and he he's going to resolve this matter. Thanks alot. Share this post Link to post Share on other sites
MikeMcNair 0 Posted August 4, 2011 look in the movement, the c clip is in there somewhere!! if you dont find it you may have further issues. the clip is too big to go through the hole the pusher does, so its still in there somewhere bro. Share this post Link to post Share on other sites
Comex 0 Posted August 5, 2011 Mike, do you have a tip to open up the case back of the SA? I don't have a opener for it. And if I need it, do I have to order a 38 mm? Thanks alot. Share this post Link to post Share on other sites
Cynikal.Mindset 1 Posted August 5, 2011 Ball of duct tape will open it up Share this post Link to post Share on other sites
Comex 0 Posted August 5, 2011 Really, I read it before but a I was a bit hesitant about it. Share this post Link to post Share on other sites
Comex 0 Posted August 5, 2011 (edited) That works! I'm going to look for that c-clip now. Thanks for the help Found it already!!! It was stikking on the case back, thank god. Sadly not useable anymore. Mailed Mark if he could send me some new ones (just to be sure) Edited August 5, 2011 by Comex Share this post Link to post Share on other sites
MikeMcNair 0 Posted August 5, 2011 Good stuff, be sure to lube the o ring before putting it back together . And also, silicone the pusher before it goes in so it seals better Share this post Link to post Share on other sites
Comex 0 Posted August 5, 2011 But thank god that I had a 21j PO laying around where I could salvaged that c-ring from. Share this post Link to post Share on other sites