tommylad 0 Posted September 20, 2011 Hi guys, I tried to switch my bracelet for a rubber strap on my 42mm Planet Ocean recently. Problem is, I can't get the spring bar to stay in even though its the right size., I'm having real problems forcing it in properly. Is this type of watch particularly difficult to switch straps? Or are rubber ones particularly difficult?Or is it something I'm missing? I have the right tools for the job. Share this post Link to post Share on other sites
onionbag 1 Posted September 20, 2011 I found that the distance from the radius on the strap that fits snug against the case is too great i.e. that the springbar cannot seat in its drilled hole. What I did was this. I fitted a 40mm flap wheel in my drill and used that to recreate the radius on the end of the strap, in effect I altered the distance between the thru' hole for the springbar and the contact point of the strap against the case. Then I two-part epoxied it. Hope this helps. Share this post Link to post Share on other sites
tommylad 0 Posted September 20, 2011 I found that the distance from the radius on the strap that fits snug against the case is too great i.e. that the springbar cannot seat in its drilled hole. What I did was this. I fitted a 40mm flap wheel in my drill and used that to recreate the radius on the end of the strap, in effect I altered the distance between the thru' hole for the springbar and the contact point of the strap against the case. Then I two-part epoxied it. Hope this helps. Sorry, I didn't really understand that. I have fitted the end with the buckle on properly and that is fine. It is the other part that's the problem. I'm regretting taking the bracelet off because the rubber strap is difficult to get off too. There must be an easier way. Share this post Link to post Share on other sites
narikaa 129 Posted September 20, 2011 FFS All thats needed is to fit the rubber strap's springbars with the strap at right angles to the watch Once in you pinchgrip and support the springbar position as you rotate the strap home into its correct position That will have a nice degree of tension within the rubber forcing a perfect fit at the case - which you will lose the instant you decide to cut/reshape it after failing with a wrong 'straight in' approach to fitting the strap . Share this post Link to post Share on other sites
onionbag 1 Posted September 20, 2011 Yes it's not very clear is it? Is the springbar in the other half of the strap not seating properly? If so it's because the hole in the strap is misaligned with the holes in the case. You can remove some material from the end of the strap which sits against the case, or you can bend the springbar so that the ends 'jut' forward, enabling them to locate. If you remove material from the end of the strap you must be careful not to remove to much. Share this post Link to post Share on other sites
tommylad 0 Posted September 20, 2011 Thanks for the help guys. I will try Narikaa's option later. For now I have just put the bracelet back on. I was getting so frustrated. Cheers. Share this post Link to post Share on other sites
MikeMcNair 0 Posted September 21, 2011 FFSAll thats needed is to fit the rubber strap's springbars with the strap at right angles to the watch x eleventeen guys, its EASY!!!!!! Share this post Link to post Share on other sites
tommylad 0 Posted September 23, 2011 The right angles trick worked a charm. It really was very easy. Thanks Narikaa and Mike. Share this post Link to post Share on other sites
narikaa 129 Posted September 23, 2011 Come Robin our work here is done . Share this post Link to post Share on other sites