ebzen02 341 Posted February 28, 2012 Lol! Here you go.. Did not go for high end swissstuff, but these worked well. http://www.micromark.com/12-piece-micro-file-set,7847.html Share this post Link to post Share on other sites
ebzen02 341 Posted February 28, 2012 Those corners are pretty easy to fix, btw.. Share this post Link to post Share on other sites
Amit 72 Posted February 28, 2012 Seriously WTF have you done I can't see or understand from the posts. Share this post Link to post Share on other sites
ebzen02 341 Posted February 28, 2012 For the haters... You too can have a rep CG look like this with the right level of sick obsession! Share this post Link to post Share on other sites
ebzen02 341 Posted February 28, 2012 Seriously WTF have you done I can't see or understand from the posts. Sometimes the greatest change is the smallest tweak. Share this post Link to post Share on other sites
Rav747 0 Posted February 28, 2012 Ebzen is smokin' the good sheet! Share this post Link to post Share on other sites
ebzen02 341 Posted February 29, 2012 I wish..drug tested this week for a new job, so have been ganja clean! Share this post Link to post Share on other sites
greg_r 81 Posted February 29, 2012 "How Far Can OCD Go..?" Pretty damned far Nice job, though, Zen Share this post Link to post Share on other sites
NFleischer 4,355 Posted February 29, 2012 I like it too. Looked kinda beveled before. Share this post Link to post Share on other sites
seoulbrova 0 Posted March 1, 2012 ebzen, do you think these files would work on polishing down the 'nipple' on the cannon pinion? Share this post Link to post Share on other sites
Luthier 1 Posted March 1, 2012 No, you'll bend it. Unless you have very, very steady hands. Share this post Link to post Share on other sites
