Jump to content
Sign in to follow this  
dingle

my first pam...183

Recommended Posts

dingle

I received my 183 friday. Awesome piece except something is wrong with the movement. I found out it is fully wound but the second hand only runs until it hits the 40 sec mark. I can turn the crown 1/4 turn and it will start back but with the same result. I am going to take houndoggies and rep-racers advice and send it back to sead if my watchsmith can do anything with it.I gave it to him today to see what ,if anything he can do. any comments? any others had this happen before?

Share this post


Link to post
Share on other sites
greg_r

:( What a pain in the butt.

Share this post


Link to post
Share on other sites
dingle
:( What a pain in the butt.

 

yes, but not as bad as the prostate exam i had recently.

Share this post


Link to post
Share on other sites
dingle

anybody else care to chime in?

Share this post


Link to post
Share on other sites
jameo210369

Nice to here that you sent her to a watchsmith rather than just send her back, I am hoping that it will be a quick fix. a bit of grease on the dial or something silly. If it isn't you can send her back knowing you've tried your best DB :boobies2:

Share this post


Link to post
Share on other sites
KBH
anybody else care to chime in?

Sounds like something simple. Probably a 10 minute fix.

Share this post


Link to post
Share on other sites
dingle
anybody else care to chime in?

Sounds like something simple. Probably a 10 minute fix.

man i hope so. this watch is sick. especially the lume.

Share this post


Link to post
Share on other sites
prestigewatchco

At a guess I would say the dial is loose. Either the retaining screw needs tightening or the leg has snapped off either is a simple fix. Worst it could be is if it's been relumed they have used too much lume and the dial is too thick in that event not such an easy fix

Share this post


Link to post
Share on other sites
mad dawg

As per above, I am also suspicious the seconds hand is catching on something. Is it touching the hour or minute hands?

Share this post


Link to post
Share on other sites
dingle
As per above, I am also suspicious the seconds hand is catching on something. Is it touching the hour or minute hands?

 

nope. the hour and minute hands are free and clear. The second hand looked to be sitting "low" as in "right up" against the dial.

Share this post


Link to post
Share on other sites
Member X

Might just need the hands re-setting then?

 

My BP scrapes around the bottom half of the face :( so I need to get mine done too!

 

Unless they've used the wrong movement and the cannon pin is too short?? (I think that's the terminology?)

Share this post


Link to post
Share on other sites
dingle
Might just need the hands re-setting then?

 

My BP scrapes around the bottom half of the face :( so I need to get mine done too!

 

Unless they've used the wrong movement and the cannon pin is too short?? (I think that's the terminology?)

 

don't have an effin clue. I will update in a couple of days when I get it back.

Share this post


Link to post
Share on other sites
dingle

well my friend the watchsmith was not able to do anything. :thumbsup: I think he was scared of the lume. :D . anyhow, i am sending it back to sead today and will let you know what happens.

Share this post


Link to post
Share on other sites
Member X

lol

 

Good stuff :thumbsup:

 

Fingers crossed things are resolved quickly!!

Share this post


Link to post
Share on other sites
dingle

went to the post office today to ship it back and they are closed form 1:00 to 2:00. WTF. my patience is starting to wear thin.

Share this post


Link to post
Share on other sites
dingle

Well I shipped the watch back to the address that was on the original package. I have recently found out that his return address is different than the one he ships from.WTF! The watch shows being delivered on 11/14 but I have yet to receive a confirmation from sead that he actually got it.

Noob mistake I guess. May have lost $320.00 down the tubes. Has this happened to anybody else?

 

bummed,

dingleberry

Share this post


Link to post
Share on other sites
AustinTech

I bet it will turn up. Just may take Sead a bit longer to get it turned around to you.

Share this post


Link to post
Share on other sites
dingle

sead says I should have it by the end of the week. woot, woot! :santa:

Share this post


Link to post
Share on other sites
trailboss99

Good to hear mate!

Sean is usualy damn good with A.S.S

 

 

Col.

Share this post


Link to post
Share on other sites
Silverspeed

Good to hear dingle...the 183 is a great watch

Share this post


Link to post
Share on other sites
dingle
Good to hear dingle...the 183 is a great watch

 

can't wait. ever since i seen yours i've been smitten

Share this post


Link to post
Share on other sites
Silverspeed

you mean this one....??

 

IMG_4118kopie.jpg

Share this post


Link to post
Share on other sites
dingle
you mean this one....??

 

IMG_4118kopie.jpg

 

dammit, dammit, dammit. I want this.............now!

Share this post


Link to post
Share on other sites
Silverspeed

just for you DB....

 

IMG_4116kopie.jpg

 

IMG_4121kopie.jpg

Share this post


Link to post
Share on other sites
dingle

new guys are suppose to be nice. your killing me here.

 

:irish_dance:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×