J.Eric 693 Posted October 30, 2012 Hi Guys, I recently picked up a 16710 GMT II from Chris at 10:10 Repair. I have always wanted one. I like the red GMT hand and aluminum bezel better than the green / ceramic combo. The only flaw was a horribly printed rehaut. An easy enough fix with a little Cape Cod. It was just printed on. The results look good. Now this is were I messed it up. The crown had a little wobble to it so I was going to swap it out with another crown, but while unscrewing the stem it snapped in half. I only got to wear it one time. I was wanting to replace the stem but not sure where to get a replacement I know it has a 21j movement and the only markings on the movement are a 'W' sitting on top of an 'O' Thanks again Guys, Any help in locating a replacement stem would be greatly appreciated! Hi Guys!! I received a letter yesterday from Chris at 10:10 containing one itty bitty stem. Chris sent it to me after I managed to break mine. Chris is just an awesome stand up guy!! I would never hesitate to recommend him to any one! Thanks again Chris and all the wonderful people on the forum. Here are a few new pics........... Share this post Link to post Share on other sites
10:10 Watch Repair 1 Posted October 30, 2012 I should have a stem here for you. Rehaut looks a lot better BTW. Share this post Link to post Share on other sites
Balad1 0 Posted October 30, 2012 Just had to be a Mr. Fix it didn't you? Even a dumb ass like me doesn't go there. Share this post Link to post Share on other sites
dalboy 2 Posted October 30, 2012 Prefere it without the rehaut..10/10 willsort ya out.. Dal........ Share this post Link to post Share on other sites
Rob Roy 35 Posted October 30, 2012 The movement is a DG2813 by the looks of it. Col Share this post Link to post Share on other sites
Balad1 0 Posted October 30, 2012 Have you considered this as a viable alternative to returning your rep for service? Share this post Link to post Share on other sites
J.Eric 693 Posted October 30, 2012 Thanks guys for all your help!! I still have plans to drill the lugs and add a jubilee bracelet. Share this post Link to post Share on other sites
DKaiser Söze 0 Posted October 30, 2012 Thanks guys for all your help!! I still have plans to drill the lugs and add a jubilee bracelet. good deal. keep us updated. I'd like to see how this project turns out. Share this post Link to post Share on other sites
decus 0 Posted October 30, 2012 Thanks guys for all your help!! I still have plans to drill the lugs and add a jubilee bracelet. When you decide to drill the lugs. Maybe you can do a vid an upload it here? Now that'd be worth watching... Share this post Link to post Share on other sites
10:10 Watch Repair 1 Posted October 30, 2012 Thanks guys for all your help!! I still have plans to drill the lugs and add a jubilee bracelet. One word: carbide Share this post Link to post Share on other sites
