alan7890 0 Posted January 28, 2013 Hi guys, got my planet ocean from WI a few weeks ago and the crown did not seem to screw back in fully, it would turn a bit and then be tight so i thought thats just how they were. today i go to set it because have not worn it for a while and the crown will not screw back in at all, its like it will not catch on to the thread, is there anything i can try to fix it or is there anyone on the board to send it to to be fixed, if i take it to a local watch repair will they not touch it with it being a rep, love the watch and just want it fixed, thanks for any help. Share this post Link to post Share on other sites
Luthier 1 Posted January 28, 2013 Open the case, and push the tube 0,5mm out of the case. Easy fix. Share this post Link to post Share on other sites
alan7890 0 Posted January 28, 2013 Thanks Luthier will give that a try now. Share this post Link to post Share on other sites
alan7890 0 Posted January 28, 2013 oops it snapped, think it was already a bit faulty, did not push on it much, is this still repairable or would it be cheaper ordering a new one. Share this post Link to post Share on other sites
Crusader 0 Posted January 28, 2013 (edited) This is really common problem on the last 42mm PO, lots of issues on forum. I think usual procedure is to order new (gen) tube and crown and get them installed. Edited January 28, 2013 by Crusader Share this post Link to post Share on other sites
Tits McGee 7 Posted January 28, 2013 Open the case, and push the tube 0,5mm out of the case. Easy fix. Thanks Luthier will give that a try now. oops it snapped, think it was already a bit faulty, did not push on it much, is this still repairable or would it be cheaper ordering a new one. Share this post Link to post Share on other sites
