okabum 0 Posted June 27, 2010 (edited) Hello Here I show you Oki´s vintage watch finally finished, more than 4 months awaiting all parts. Initially was for a CG change, then we decide to relume again, less vintagized. Then when it´s modded again, we find another movement, this time was a cort 616, so reingrave movement and fully serviced made by Loosetime When awaiting, I took his case and decide to reshape to a more gen apperance Again when is fully finished we decide to wait until a batch of NW casebacks arrive and can adjust inner ring for a good fit. Then when is about to finish again, plexy was on production so decide to wait and change it Then my injury, so more wait This last week, I have modded bezel to house a K25 plexy now it´s finished, and with a new improvement, a new tube and new adjusted crown. Tube, following clint eastwood post was made initially in bronze, but due to poor quality when making inner o-ring space piece break down, so finally made in brass, so in 2-4 months will be blackened. So a little list of parts and origin place DSN - case Jacksontse - crown Ross - Dial Loosetime - movement servicing Nightwatch - display caseback and solid caseback. okabum - hands lume springbars tube inner ring movement engraving case engraving K25 plexy And now these bad pics as usual Edited June 27, 2010 by okabum Share this post Link to post Share on other sites
KBH 7 Posted June 27, 2010 Nice. Particularly like the lume and, of course, that good looking movement. Share this post Link to post Share on other sites