BC1221 44 Posted October 25, 2014 I'm stealing darth Alex's photo but it's basically the thin gasket that goes between the retaining ring and the bezel. The one in my DJII is stretched and won't seat right in the bezel and I can't find one to save my life. I know all the ceramic bezeled rolexes have them too. It's about 35mmx.5mmx.30mm almost paper thin The bezel will stay on as it is but I'd rather not keep it that way. My options right now seem to be source one and replace. If I can. Cut a little bit off and glue or melt it back together to have a tight fit Or figure out a way to shrink it.. Any ideas? Surely I can't be the only one this has happened to... Share this post Link to post Share on other sites
Arism 26 Posted October 25, 2014 (edited) The one that comes to mind is Clark's on ebay. LINK ---> Rolex Sapphire Crystal Gaskets You'd need to know the specs of the Rolex equivalent crystal; part number etc. Should do the trick. Hope that helps Edited October 25, 2014 by Arism Share this post Link to post Share on other sites
BC1221 44 Posted October 25, 2014 It's not a crystal gasket. Those are too big. Even the smallest ones Clark sells is way to big. Share this post Link to post Share on other sites
