Cannibal 0 Posted November 26, 2014 So I know these are tough to size but holy crap! Any tips other than taking it to a watchmaker? Share this post Link to post Share on other sites
Not Quite Dead 9 Posted November 26, 2014 Which type I have got 3 sorts in my collection and the screws were the only one that did not cause aggravation. The pins with the separate centre tube do take the biscuit though. I have put mine on rubber! Share this post Link to post Share on other sites
Cannibal 0 Posted November 26, 2014 Mine has the pins. If this annoys me too much, it may go in the M2M sales area. LOL Share this post Link to post Share on other sites
Not Quite Dead 9 Posted November 26, 2014 They do get easier after you have bent a few pins and broken the end of the extraction tool, chinese steel who would have thought. Share this post Link to post Share on other sites
flyr 4 Posted November 26, 2014 You need to use a pin punch and bracelet block. Share this post Link to post Share on other sites
Cannibal 0 Posted December 2, 2014 Update on this... I got out my trusty watch tool kit (bracelet block, pin punch, etc) and got it done perfectly on the first attempt. SWEET! And then I put the watch on and the clasp is so weak, it pops open immediately. Crap! Contacted the ebay seller and he's sending me a sized, replacement with the promise to check the clasp, and once the replacement arrives, that I mail back the defective one, 'using the most economical mail method that benefits you'. Stay tuned. Share this post Link to post Share on other sites
