nummer14 528 Posted May 12, 2018 Hi Guys, Today I received my Deep Sea - Sea Dweller, and I love it, I have also sourced a RubberB strap, complete with clasp, for it. However both the bracelet and the RubberB are a bit too big, now I can of course remove links from the bracelet, but not from the rubber strap, so I would like to remove the divers extension. However I have no clue how. I searched all the forums, and tried all methods, seeing if at certain angels the last bit would turn so I can reach the screw, but alas, no such luck. When I extend the bracelet completely the screw is partly visible (circled in red), but not enough to remove it. I also noticed that there are 2 small holes at the inside of the slidelock (also circled in red), and it looks like springbars in there too, I've tried opening these in order to remove the link, but no such luck again. Anybody have any idea on how to do so? I have added 2 close-ups from the bracelet (easier to photograph than the rubber strap since that's on the watch) but both the bracelet and the rubber strap / bracelet have the exact same mechanism Any help is greatly appreciated And a shot of the watch with the lovely RubberB strap; Share this post Link to post Share on other sites
Luxuracer 14 Posted May 12, 2018 @nummer14 .... Go here for full instruction; https://www.repgeek.com/rolex/291426-dive-extension-link-removal.html Share this post Link to post Share on other sites
nummer14 528 Posted May 12, 2018 7 minutes ago, Luxuracer said: @nummer14 .... Go here for full instruction; https://www.repgeek.com/rolex/291426-dive-extension-link-removal.html super! that is indeed what I was looking for! must have overlooked this one, thank you so much! Share this post Link to post Share on other sites
TraceF3 0 Posted December 4, 2023 On 12/05/2018 at 13:13, Luxuracer said: @nummer14 .... Go here for full instruction; https://www.repgeek.com/rolex/291426-dive-extension-link-removal.html I can't seem to get the link to work. I have the same problem. The slide won't come out far enough to get to the screw. Share this post Link to post Share on other sites