Hazz 0 Posted June 15, 2012 I have a missing pin on the CG of one of my Pams, any way to repair ? Share this post Link to post Share on other sites
Member X 91 Posted June 15, 2012 You mean the pin that holds the lever in place? Stainless Steel rod of the correct diameter and cut to the correct length should fit, although what these measurements are I have no idea Or, easier, just buy a whole replacement CG Share this post Link to post Share on other sites
Hazz 0 Posted June 15, 2012 Tried 2 different CG's but neither licked to the crown, will try find a rod mmmmm? Share this post Link to post Share on other sites
Hazz 0 Posted June 15, 2012 Nah, wont work, the rod needs to be tapered, too small to thin down. Share this post Link to post Share on other sites
onionbag 1 Posted June 17, 2012 Taper pins here mate, http://www.rnhorological.co.uk/pins%20and%20springbars.htm Share this post Link to post Share on other sites
