12lurk 0 Posted December 18, 2012 What is the collective wisdom on punching holes in rubber straps? I have an AP diver v3 and could use it to be "1/2 hole" tighter. Can this be done? Should this be done? How is it done while avoiding rubber splitting? Thank you in advance. Share this post Link to post Share on other sites
houndoggie 58 Posted December 18, 2012 I say the same thing about my wife! Share this post Link to post Share on other sites
ronin007 0 Posted December 18, 2012 Might work with a leather hole puncher but the hole will be round,maybe a shoemaker would have a square leather punch tool,dont blame me if it doesnt work,the leather punch does work though saw it on rwi,just looks odd compared to the square holes Share this post Link to post Share on other sites
Dendo 93 Posted December 18, 2012 You can buy square hole punches - but it may well weaken the rubber and allow a rip between the two regular holes. Now HD should not even start to comment on this..... please.... PS - your wife is just getting back from pregnancy - cut her a break on being loose Share this post Link to post Share on other sites
houndoggie 58 Posted December 18, 2012 You can buy square hole punches - but it may well weaken the rubber and allow a rip between the two regular holes. Now HD should not even start to comment on this..... please.... PS - your wife is just getting back from pregnancy - cut her a break on being loose She is fully recovered! That only leaves.... :( Share this post Link to post Share on other sites
P4GTR 0 Posted December 18, 2012 if it were something where you were adding on to the 1st or last hole I could punch one for you. While technically doable, punching in between existing holes would not leave enough rubber behind to maintain the integrity of the strap. Share this post Link to post Share on other sites