projectologist 0 Posted February 16, 2013 I decided the roller-bearing pin needed some refinement. On my Noob cg the little pin was sitting a little above the lever tip and was not dead flat. So out it came, got flattened, polished and re-installed flush. Couple of phone pics, the first one shows the pin finished and getting ready to be pushed flush. Next pic shows fully finished cg... outer lever tip shortened and rounded per gen, cg body and lever edges polished, cg pin also flattened - polished - recessed just a hair below flush with cg body. Share this post Link to post Share on other sites
