CG Lever running loose

[borisvos 0]

Hi lads,

 

I ordered a PAM111 with ReplicaMake. It arrived, but the CG lever is running amok. The axis is loose, so it will not stay in place. Is there any way I can solve this on my own? I am a proper modding novice, so please be gentle with me.

Thanks in advance guys!

[dingle 57]

Hi lads,

 

I ordered a PAM111 with ReplicaMake. It arrived, but the CG lever is running amok. The axis is loose, so it will not stay in place. Is there any way I can solve this on my own? I am a proper modding novice, so please be gentle with me.

Thanks in advance guys!

 

 

Check with Lay (replicamake) and see if he can send you another CG. should be easy to replace.

[borisvos 0]

I might do that. But this is also a good opportunity to do my first carefull babysteps in the wonderful world of modding

[dingle 57]

I might do that. But this is also a good opportunity to do my first carefull babysteps in the wonderful world of modding

 

just read this on HD's tutorial. Might be the easiest fix

 

"plumbers epoxy. to tighten the lever around the pin. You can use hot glue (works well) or gorilla glue (messy but works), or whatever else you may think will do."

[sesshin 0]

Here is a detailed write-up of the hot glue mod over at RWI

http://www.replica-watch.info/vb/showthrea...ght=crown+guard

[greg_r 81]

Houndoggie's CG tutorial here (includes tightening the lever as well as sanding the pin to be more gen-like): http://www.replica-watches-guide.com/forum...?showtopic=2026

[ReplicaMake 0]

borisvos, PM sent

[dingle 57]

borisvos, PM sent

 

:(