Olig7475 0 Posted June 3, 2014 Tired line but true "upon getting a watch have it serviced/ looked over by a smith" just the cost of doing biz................ Wouldn't have made much difference in this case, it arrived like this Share this post Link to post Share on other sites
court 12 Posted June 3, 2014 All epoxy resins have VOC's (Volatile Organic Compounds) and so give off fumes that I would'nt want near a watch movement TBH. Share this post Link to post Share on other sites
P4GTR 0 Posted June 3, 2014 No glue. You can either pull the movement ring out, tap the hole and replace the screw/tab or put the case back on and be done with it. If the dial is moving around when you set the date/time or operate the chrono's, you will need to address the issue sooner rather than later. If this is new from a TD, see if they can send you a replacement movement holder ring and screw. That would be the ideal resolution. Share this post Link to post Share on other sites
Olig7475 0 Posted June 3, 2014 Thanks guys.....I'll put the glue away!!!!! It all feels tight, no movement when I set the time and as it's a 7750 I don't use the chrono's ha ha. Share this post Link to post Share on other sites
