kennycoder 97 Posted February 23, 2015 Got my regmariner today and the datewheel overlay is couple of degrees misaligned. Drives me mad as you can imagine. I saw couple of threads over here (ty LightGeek).. but all for 2824 and 2836 movements. Has anyone performed DW de-glueing / alignment on a 21j? If so, what to watch out for? I'll try fixing this today/tomorrow and will post some pics anyway. Thanks in advance. Share this post Link to post Share on other sites
SSTEEL 0 Posted February 24, 2015 Remove the DWO from the DW, clean/etch away all traces of glue/print from them both, and then use slow cure adhesive, this will give you plenty of time to manipulate the DWO into position whilst trial fitting the dial, removing it to manipulate more, and refit etc. Share this post Link to post Share on other sites
steve123 0 Posted February 24, 2015 Remove the DWO from the DW, clean/etch away all traces of glue/print from them both, and then use slow cure adhesive, this will give you plenty of time to manipulate the DWO into position whilst trial fitting the dial, removing it to manipulate more, and refit etc. perfect, got a datejust i have to do this with.. thanks Share this post Link to post Share on other sites
wimpie007 108 Posted February 24, 2015 Well tried removing a few, always messing up the movement in the process ;-) Always loose those little springs and the screws of that plate are too small ;-) Share this post Link to post Share on other sites